NOYITO Voltage to Frequency Module 0-10V to 0-10KHz Signal Conversion Module

NOYITO Voltage to Frequency Module User Manual https://1drv.ms/b/c/4a0865b22350d05c/IQBc0FAjsmUIIIBKhwAAAAAAAWsN-KElrmb5HCnVYggDyuY?e=2yz7yQ Features 1. Input voltage, output frequency signal. 2. The output signal can be fine-tuned, and the potentiometer can be adjusted to calibrate the corresponding relationship between voltage and frequency. 3. The output of this module can be supplied to the driver as a pulse signal. When it is used with the driver, the common anode wiring is required. The relevant wiring instructions are as follows: OC-OUT: To connect the drive's PUL- terminal or PUL terminal 12-30V: Connect to the PUL+ terminal of the driver or the common terminal +5V. Technical Parameter: Working voltage: 13.5V-30V. Input controllable voltage range: 0-10V. Output frequency range: 0-10KHz. 3. Hardware introduction and description Wiring Instructions: VCC: Power supply +. GND: Power supply ground - . IN+: input voltage signal +. IN-: input voltage signal - . OCOUT: Signal collector output port (use this output port when matching the driver). FOUT: Frequency output port (general frequency output port). Two separate outputs, OC-OUT is NPN, FREQ-OUT is IC output. The common cathode is used with the "-" GND of the power supply. When the common anode is connected, it is used together with the power supply "+" VCC. When the common anode is connected, if it is 13-24V power supply, a 2.7KR resistor should be connected in series, and if it is DC12V power supply, a 330R resistor should be connected in series. Module Working Instructions: Connect the positive and negative of the 0-10V voltage signal to IN+ and IN- respectively, and there is a corresponding frequency signal output between FOUT and GND. Correspondence between input and output: 1V = 1KHz. 10V = 10KHz. If there is a deviation in the corresponding relationship during use, you can adjust the potentiometer on the board to calibrate Package Included: 1Pcs NOYITO Voltage to Frequency Module

• NOYITO voltage-to-frequency module is a module that can generate different frequencies depending on the input voltage. It can convert 0-10V voltage into a frequency pulse signal of 0-10KHz.
• Working voltage: 13.5V-30V.
• Input voltage range: 0-10V.
• Output frequency range: 0-10KHz.
• The output signal can be fine-tuned, and the potentiometer can be adjusted to calibrate the correspondence between voltage and frequency.